Quality Assurance is an integral part of Delta Pacific Product Inc's core competencies and plays a critical function in providing our customers with quality product. Since over 78% of our customers are medical related, it is imperative that the plastic products we produce meet or exceed the specific tolerance requirements that are established by our clients. Delta Pacific Products Inc. is ISO 9001:2008 certified and continues to build upon it's reputation for exceptional quality and attention to detail.
Throughout the production process, all parts are inspected at different levels in order to maintain part consistency and accuracy.
Initial Inspection - At the press, our operators are trained to identify part inconsistencies, such as: flash, shorts-shots, voids, burns, sink, cracks, and any abnormal characteristics on the part. During the production process, critical inspection points are monitored, verified, recorded and are available to the customer at any time.
Detail Inspection – Once parts are produced they are sent to our Quality Assurance Department where they inspected thoroughly to ensure dimensional accuracy. Sophisticated equipment, tools and fixtures are used in this process, consisting of:
ROI Vision System
Micrometers
Veneer Calipers
Special fixtures if needed
Gauge Pins
All items are calibrated
Guage R & R studies
Histogram and X bar charts available
Based on the requirements of the customer, Delta Pacific Product Inc. offers a variety of Inspection and Validation reports consisting of:
Complete First Article Inspection (FAI) Reports
Critical Dimension Inspection (IQC Points)
Material Certifications
Validation Reports:
Performance Qualification (PQ)
Operational Qualification (OQ)
High Molding Process
Low Molding Process
Nominal Molding Process
Installation Qualification (IQ)
CPK Analysis
Final Inspection – A final visual inspection will be conducted in our shipping and receiving department before parts are packaged and shipped to customer to assure that packing slips and C of C's are correct.
